Dual Platen Pneumatic Heat Press 16×24 Inch (40×60 cm)

Dual platen pneumatic heat press for garment printing

This dual platen pneumatic heat press combines a nominal 16 × 24 inch format (supplier specification: 40 × 60 cm) with two fixed loading stations and a sliding upper heating head. It is designed for print shops applying compatible transfers to flat garments and textile items. The operator can organise loading and unloading across two worktables rather than repeatedly preparing a single station.

The selected configuration uses a 220 V electrical supply and 3.8 kW heating power. Pneumatic pressing requires a suitable compressed-air supply. It is a semi-automatic machine: the operator positions the garment and transfer, controls the workflow and checks each finished piece. It should not be confused with a fully unattended press or a hydraulic model.

Two worktables, one moving heated head

The upper head slides between the two silicone-pad worktables while the garment beds remain fixed. This arrangement helps keep the laid-out garment in place during head positioning. It also gives the operator a separate surface for preparing the next transfer. Actual output depends on the transfer dwell time, garment handling, operator experience and required finishing steps; no fixed hourly production rate is promised.

Digital controls and practical machine details

The integrated digital controller provides temperature and time settings, with a production counter shown in the supplier diagram. The machine layout includes a manual start control, power switch, pneumatic cylinder, air regulator and emergency stop. The supplied illustrations show the heating plate, silicone pads and floor stand on castors. Confirm the final supplied configuration during your order discussion.

40 × 60 cm model specifications

The temperature range is a controller specification, not a recommended pressing temperature. Always use the time, temperature, pressure and peel instructions supplied with the particular transfer material. The supplier specification image covers several sizes; the 40 × 60 cm column applies to this listing. Packing references shown in that image are not the installed machine footprint.

Suitable transfer applications

• DTF transfers: press fully prepared transfers onto suitable garments using the transfer manufacturer’s settings.
• Heat transfer vinyl: apply compatible cut vinyl to flat textile areas after checking the material’s temperature and pressure requirements.
• Sublimation: use suitable polyester fabrics or approved coated flat blanks. Ordinary untreated cotton does not produce the same result as a sublimation-ready substrate.
• Textile personalisation: consider T-shirts, compatible tote bags, flat cushion covers and similar items that can lie evenly within the platen area.

Setup and operating workflow

Plan a level, stable installation area with clearance for the sliding head, both loading stations and safe operator access. Arrange an appropriately rated electrical circuit and a clean, regulated compressed-air connection in accordance with the machine instructions. Purchase a suitable compressor separately. Ask DTFShop to confirm the required compressor capacity, hose fittings and supplied accessories before arranging installation.

1. Check the machine, air connection and silicone pads before switching on.
2. Select the transfer supplier’s recommended settings and allow the press to reach a stable temperature.
3. Lay the garment flat and position the transfer without seams or bulky fittings obstructing even contact.
4. Position the heated head correctly, keep hands clear and run the press cycle following the machine instructions.
5. Follow the transfer’s peel and finishing directions, then inspect a test piece before starting a batch.

Price and order information

Regular price: ₹1,40,000. Offer price: ₹90,000, excluding GST. The offer reduces the machine price by ₹50,000. Freight, unloading and any installation or accessory charges should be confirmed in the final quotation. The compressor is not included and must be purchased separately. The heating coil carries a one-year warranty. Confirm dispatch availability, training arrangements and the detailed coil warranty terms with DTFShop before payment.

For help choosing transfer materials or planning your printing setup, contact DTFShop, the ecommerce brand of Prolificgeeks. Share your garment type, transfer size and expected workflow so that the supplied machine and accessories can be checked against your requirements.